Since I didn't make these shirts, I didn't have any extra fabric. He was willing to have me cut off some from the tail to make patch pockets, but I kind of hated to do that, and kept putting it off. Finally, he suggested that there might be a way to do an inside pocket, and I immediately got started. I was lucky enough to have scrap fabric that was a match to the background of the shirts. For two I used a light tan linen, and the other a white broadcloth. The shirts are one stripe, one seersucker stripe, and one floral.
What I did was very fast. It's basically a welt pocket with no welts. With pinking shear, cut a strip of interfacing longer and wider than the box, and stitch one pocket bag piece to each long edge, with the fusible side away from them. I used a triple zigzag so it would be very flat, and stitched twice on each piece, once at the top of the bag, and once at the bottom of the interfacing.

Photo Link
Place the piece in position on the right side of your shirt, fusible side up. Stitch the box, as per a welt pocket. Clip open and turn to wrong side. Fuse.

Photo Link
Edgestitch around the box, then topstitch a little further away for stability.

Photo Link
Press the top bag piece down where it's free from the fusible. Pin it to the lower edge of the lower bag piece. Stitch. This seam will fall a little way up into the pocket bag. Stitch your side seams up as far as the fusible. If you want your seam at the bottom, you must either figure and measure carefully when you cut, or make the top bag longer and trim to match the bottom bag before you stitch. There used to be some method that had you do this anyway, but I don't remember the logic behind it. I just did it this way because it worked out this way.

Photo Link
From the right side, stitch again over the line of topstitching above and at the sides of the box. This will close your side seams enough for normal use. Finish with a little handstitching if needed.

Photo Link
Good eye Liana (as usual).





Don't know that I agree about the collar points, could be a matter of garment sway from walking but I do see another problem with it, bubbling on one side near the dart (see these photos I've made notes on.)
The taupe style ...that has GOT to be a proto, a last minute addition to the line. I found three problems with it, rather glaring imo. The buttons don't line up,
the aforementioned neckline bubble (same block as the white one?)
and that placket thingy in addition to buckling, is crooked.
Again, see my photos.
RE: zipper. The end point pucker is the least of it really, you can see it's puckering well before that end point. Pretty lousy imo. Also, look at that seam on the sleeve; it's caving inwards.
With all that embellishment weight, that really needed some kind of infrastructure to reinforce the seam.